KOBUS PIPE PULLER CONSUMABLES

The Kobus Pipe Puller uses a couple of specially designed ‘consumables’ for each pull.  Firstly, the steel Pulling Cable gives the optimum pulling load-to-cable diameter ratio, crucial for a successful pull.  Secondly, the Kobite Bonding Compound is a special, unique formulation 2-pack compound.  This cures to form a composite ‘rope’ between the pipe and cable to aid the pull.  Importantly, this is only required when replacing lead pipes.

For information on Kobus Pipe Puller Accessories, such as towing heads, leader cable, expanders, and K-Line drawstring, click here

8mm diameter pulling cable recommended for 1/2″ internal diameter pipe

Specially constructed cable with exceptional strength

Minimum Breaking Load 6.5t

Available in 1 metre length increments from 5m to 15m

Non standard longer lengths available on request

Supplied with 29mm/36mm expander as standard

10mm diameter pulling cable recommended for 3/4″ internal diameter pipe and larger

Specially constructed cable with exceptional strength

Minimum Breaking Load 10t

Available in 1 metre length increments from 5m to 25m

Supplied with 29mm/36mm expander as standard

14mm diameter pulling cable recommended for 3/4″ internal diameter pipe and larger

Ideal for galvanised steel pipe

Specially constructed cable with exceptional strength

Minimum Breaking Load 20t

Available in 1 metre length increments from 5m to 25m

Supplied with 29mm/36mm expander as standard

Specially formulated KOBITE bonding compound.  Two-pack bonding compound with catalyst.

Recommended for use with 1/2″ lead pipe to minimise risk of ‘balling up’ of lead pipe during pull

Cure time circa 20 minutes

Inject between pipe inner wall and steel pulling cable using Kobite dispensing gun

Note: wear protective gloves and eye protection – skin irritant

Click here to see more information on the KPP300 and KPP400 Pipe Puller machines